If you've cleaned the venturi and checked the float but the tank stays full, you may need to replace the or the Rotor Position Switch . If you'd like to troubleshoot further, tell me:
Debris prevents the system from sucking brine out of the tank during regeneration. 40278 water softener full
Take a broom handle and gently push down on the salt. If the top layer is hard but there is hollow space or water underneath, you have a bridge. Break up the salt carefully to allow it to mix with the water again. If you've cleaned the venturi and checked the
Ensure the drain hose is not kinked, frozen, or submerged in a floor drain. If the unit cannot "breathe" through the drain line, it cannot pull the brine solution out of the tank. How to Manually Empty the Tank If the top layer is hard but there
Avoid "rock salt" which contains impurities. Use evaporated salt pellets or solar salt.
If the tank is physically overflowing with water, you need to remove the excess before the system can reset:
Clean the small screens and the tiny flow plugs with warm, soapy water. Ensure the pin-sized holes are not blocked.