Deploy shared file access across both SAN and NAS for low-latency SAN and large scale-out NAS workflows.
Tighten all bolts from Step 1 through Step 3. If the cables feel too loose, adjust the floating pulley bracket position or use the chain links usually provided at the cable ends to take up the slack. Safety & Maintenance
Insert the center selector rod through the plates and attach the cable end to the top of the rod.
Use a silicone-based spray on the guide rods for smooth movement. Never use WD-40 , as it attracts dust and creates friction. dp dual trac 20 assembly instructions full
Start at the lat bar attachment point. Thread the cable over the top pulleys, down through the "floating" pulley block, and back up to the anchor point on the frame.
Secure the seat and backrest pads to their respective frames using the smaller hex bolts. Tighten all bolts from Step 1 through Step 3
Insert the weight guide rods into the base. Slide your weight plates on one by one.
Run the handles through a full range of motion without any weight plates pinned to ensure the cables are tracking correctly. Use a silicone-based spray on the guide rods
Lay out all bolts and nuts by size before starting. This prevents using the wrong hardware in early steps. Step 1: The Main Frame and Base Start by assembling the "skeleton" of the machine.