Press to deactivate the system. The indicators will flash once to confirm. Synchronization Procedure
If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor Gemel Txshs User Manual
Remove the screws on the back of the case and separate the two halves. Carefully remove the old battery. Press to deactivate the system
If your remote stops responding (often after a battery change or if buttons were pressed over 256 times out of range), use this procedure to re-pair it: If the bike is left deactivated for over
The system enters a 15-second "activation phase" where no alarm will be triggered. After this, it is fully active.
The TXSHS remote typically features two buttons and a status LED: Used to arm the system. Button 2 (Smooth): Used to disarm the system.
Perform the described above to reconnect the remote to the bike. Troubleshooting