Ts1162 Installation Manual !!top!! May 2026

Use the base as a template to mark screw holes. Use appropriate fasteners for the mounting surface (e.g., wall plugs for masonry). 2. Wiring and Terminals

Test the keypad by entering a valid user code to arm/disarm the assigned areas.

The Challenger system identifies each keypad by its unique RAS address, which must be set manually before the unit is powered up. ts1162 installation manual

For further technical support or to download the full PDF documentation, visit the Aritech Support Portal or Ness Corporation .

Use the internal DIP switches (usually 1–4) to set the RAS address (1 through 16). Refer to your specific Challenger panel manual for the binary address table. Use the base as a template to mark screw holes

If the TS1162 is the last device on a long RS-485 cable run, set the termination DIP switch (typically Switch 8) to the 'ON' position to prevent data signal reflections. 4. System Integration

This guide outlines the physical installation, wiring, and addressing procedures for the TS1162. Wiring and Terminals Test the keypad by entering

The is a 3-LED Remote Arming Station (RAS) designed for use with Challenger security systems. Rated at IP67 , this robust keypad is suitable for both indoor and outdoor installations, including harsh, dusty, or wet environments.