If you have a monitor and keyboard attached to your Unraid server, you can perform the reset directly from the command line interface (CLI). Log in as root .
Safely eject the drive, return it to the server, and power it on. 3. Using Unraid GUI Mode
these files or rename them to network.cfg.old to keep a backup. unraid reset network settings install
To re-enable DHCP, ensure the following line is set: USE_DHCP="yes" .
To set a manual address, set USE_DHCP="no" and define IPADDR , NETMASK , and GATEWAY . Troubleshooting Tips If you have a monitor and keyboard attached
rm /boot/config/network.cfg rm /boot/config/network-rules.cfg Use code with caution. Reboot the server by typing reboot . 2. Reset via USB Flash Drive (on another PC)
Note that many network changes in the WebGUI require the Array to be stopped before they can be applied. To set a manual address, set USE_DHCP="no" and
If your server has multiple ethernet ports, Unraid may assign them differently after a reset. Ensure you are plugged into the port designated as eth0 .