V2ray Mikrotik Online

You can use official images from Docker Hub, such as v2fly/v2fly-core .

: Create a new routing table that points the gateway to the container's IP address ( 172.17.0.2 ). DNS Considerations

: Give the VETH interface an IP address (e.g., 172.17.0.1/24 ) and assign the container a static IP (e.g., 172.17.0.2 ). v2ray mikrotik

: Set up a source NAT rule so the container can access the internet: /ip firewall nat add chain=srcnat src-address=172.17.0.0/24 action=masquerade Step 3: Prepare the V2Ray Configuration

Once the container is "running," you need to tell MikroTik which traffic should go through it. Policy-Based Routing (PBR) You can use official images from Docker Hub,

: A USB drive or high-endurance SD card is recommended to host the container to avoid wearing out the internal flash memory.

: Use /ip firewall mangle to mark packets from specific local IP addresses that you want to proxy. : Set up a source NAT rule so

You will be prompted to press a physical button on the router or perform a power cycle within 5 minutes to confirm.

/container/add remote-image=v2fly/v2fly-core:latest interface=veth1 \ root-dir=disk1/v2ray-root mounts=v2ray-config envlist=v2ray-env